Knowledge Base
Product Technical Support
Technical support for MGL products
Recent Articles
AeroVee Engine Sensor Setup
AeroVee (Sonex) Sensor Settings AeroVee uses the following sensors: CHT: Type-K or Type-J Thermocouple (Specified at ordering) EGT: Type-K Thermocouple Oil Pressure: VDO 5-bar sensor 360-001 Oil Temperature: VDO 150-degree Celsius sensor 323-055 ...iEFIS WiFi Gateway Installation and Setup
MGL iEFIS WiFi Gateway from MicroKit Installation and Setup Pre-Installation Tasks: If your unit is an iEFIS or iEFIS Lite Verify Software Revision is at least G3 1.1.2.0 If your unit is an iEFIS MX1 Verify Software Revision is at least V13 Verify ...Blaze Single Manuals
Attached are the manuals of the 3 1/8" Blaze Color Singles (Last Updated 11/16/2021) Applies to: AHRS-2 AHRS-4 ALT-6 ALT-7 ASI-5 ASV-2 EMS-2 FF-5 INFO-2 MAP-4 RPM-2 TC-5 TC-6 TP-4Setting up an MGL V16 with an audio Panel
There are some common issues our customers run into when hooking the V16 up to an audio panel. This video will explain some of these common pitfalls and how to overcome them.Using the V16 VHF COM Radio with an Audio Panel
The V16 VHF radio is a great companion with audio panels and external intercoms alike. When installing a V16 radio with the intention of using it behind an audio panel or intercom, it is important to properly configure the V16's settings for optimal ...
Popular Articles
Free Database Updates
NOTICE 08/30/2021 - ATTENTION MGL CUSTOMERS: Michigan Avionics is excited to announce that the US Navidata is once again being updated and is available for download! Also, the FAA has recently started publishing VFR sectionals on a 56-day basis ...VDO Oil Pressure Sender Settings and Wiring
Attached are settings and wiring connections for the commonly-used VDO Oil Pressure Sender. This can be used to help if you are experiencing problems or if you suspect your oil pressure sender is reading incorrectly. Remember to follow tthese 3 Steps ...Can I shorten the GPS Antenna cable?
The GPS Antenna coax cable must not be cut short. This is due to the fact that the GPS receiver inside the EFIS is tuned for the length of coax cable included. This applies to the GPS antenna included with the XTreme, Enigma, Odyssey, Voyager and ...Is my EGT probe reading correctly?
If you are unsure whether your EGT Thermocouple probe is reading correctly (MGL Avionics type-K thermocouple), there are a few simple tests you can do: CANDLE TEST With the EGT still connected to your instrument, hold the tip of the probe in the ...iEFIS and iBox User and Installation Manuals
The iEFIS and iBox Installation, Navigation and User Manuals are attached