CHT Thermocouple Probe Type?

CHT Thermocouple Probe Type?

Most Aviation CHT probes are either Type-K or Type-J thermocouples.

All CHT probes sold by MGL Avionics are Type-K. Many CHT probes available in the US are type-J. Please contact manufacturer to find out what type they are.

If you use the wrong type in your instrument setup, you will get inaccurate readings.

Type-K thermocouples normally have Red and Yellow wires.
Type-J thermocouples normally have Black and White wires.

Note that the polarity of Type-K Thermocouples is not intuitive, as Red is Negative:

TYPE-K (typical):
YELLOW = POSITIVE
RED = NEGATIVE

Note that the polarity of Type-J Thermocouples is not intuitive, as Black is often Positive:

TYPE-J (typical):
BLACK = POSITIVE
WHITE = NEGATIVE

Read more about thermocouples here:
http://en.wikipedia.org/wiki/Thermocouple

    • Related Articles

    • Can I extend CHT and EGT Thermocouple probes?

      Should you wish to increase the length of the leads of your CHT or EGT probes, this can be done. Our type-K EGTs and CHTs probes should be extended with type-K extension wire directly to the RDAC, or if the RDAC is mounted outside the engine ...

    • EGT Thermocouple Probe Type?

      Most Aviation EGT probes are type-K thermocouples (because the temperature range of type-J thermocouples is not has high as is required for EGT). All MGL Avionics EGTprobes are TYPE-K. Note that the polarity of Type-K Thermocouples is not intuitive, ...

    • CHT Thermocouple Probe Wiring and Setup

      Attached are settings and wiring connections for Cylinder Head Temperature senders. This guide can be used to help if you are experiencing problems or if you suspect your CHTs are reading incorrectly.  Remember to follow these 3 Steps first when ...

    • Thermocouple Order - which goes first EGT or CHT?

      In all MGL Avionics instruments (except iEFIS), including Velocity Singles and Infinity Singles and all RDAC connections for MGL Avionics Enigma, Odyssey and Voyager EFISs, the following rules apply regarding the order in which EGT and CHT probes are ...

    • Is my CHT probe reading correctly?

      If you are unsure whether your CHT Thermocouple probe is reading correctly (MGL Avionics type-K thermocouple), there are a few simple tests you can do: BOILING WATER TEST With the CHT probe still connected to the instrument, hold the probe ring in a ...