Connecting a Ray Allen RAC Trim or Flap Sensor to EFIS

• Related Articles

• SP-10 Used For Pitch Trim with Ray Allen trim servo motor

  Below is a schematic diagram of an SP-10 used for Pitch Trim only with a Ray Allen servo. When used with an MGL Avionics iEFIS and MGL Avionics autopilot servos, this setup will allow auto-trim of the aircraft when under autopilot control. ​

• Connecting the New-Style Rotax 912 Oil Pressure Sensor to the EFIS

  Attached is the manual for connecting the New-Style Rotax 912 Oil Pressure Sensor to the XTreme, Enigma, Voyager or Odyssey EFIS. This sensor is made by Honeywell. Note: when using the RDAC XF, you do not need to install the 100 ohm resistor - you ...

• SP-10 Trim and Flap Controller Manual

  The manual for the MGL Avionics SP-10 Trim and Flap controller is attached. Each SP-10 can handle 2 functions (for example pitch and roll trim, or pitch trim and flaps).

• Connecting a Zaon XRX PCAS Traffic Monitor to your EFIS

  Attached is the manual for connecting a Zaon XRX Portable Collision Avoidance System (PCAS) to your Enigma, Voyager or Odyssey EFIS.

• Ground Proximity and Flap Overspeed Manual for Gen 2 Odyssey/Voyager EFIS

  Attached is the manual for the Ground Proximity and Flap Overspeed Warning System in the Gen 2 Odyssey and Voyager EFIS