ECB Switch Kit LED Orientation

When assembling the ECB (Electronic Circuit Breaker) Switch Kit, the FLAT side of the LED light goes on the LEFT side when looking at the PCB in this orientation (from the front with the switch at the top):

​

• Related Articles

• Servo Capstan Kit for MGL Servos Manual

  Attached is the manual for the Capstan Kit for MGL Avionics servos ​

• MGL ECB Manuals

  Attached are the manuals and serial protocols for the MGL Avionics Electronic Circuit Breaker System.

• iBox and iEFIS Extender Analog Inputs requiring Ground Switch to activate remote functions

  The iBox and iEFIS Extender Analog inputs require momentary contact with Power (12 Volts) to activate the various remote control functions available (check in Digital Inputs setup - example below). These functions are normally activated with hat ...

• Blaze Single Manuals

  Attached are the manuals of the 3 1/8" Blaze Color Singles (Last Updated 11/16/2021) Applies to: AHRS-2 AHRS-4 ALT-6 ALT-7 ASI-5 ASV-2 EMS-2 FF-5 INFO-2 MAP-4 RPM-2 TC-5 TC-6 TP-4

• Vega Single Manuals

  Attached are the manuals of the 2 1/4" Vega Color Singles Applies to: AHRS-1 AHRS-3 ALT-5 ASI-4 ASV-1 EMS-1 FF-4 INFO-1 MAP-3 RPM-1 TC-4 TP-3