Harness Schematic for Sandia STX-165R and uAvionix EchoUAT ADS-B
Attached is the schematic for connecting both the uAvionix EchoUAT ADS-B and the Sandia STX-165R Remote Mode C Transponder.
The RS-232 wires from the STX-165R can be connected to any channel on the iBox or any channel on the iEFIS Lite or iEFIS Extender.
The RS-232 wire from the EchoUAT (ADS-B TX) must be connected to a high speed RS-232 RX channel (either channel 1 or channel 2 on the iBox or ANY RS-232 channel on the iEFIS Lite or iEFIS Extender).
Read this article for setup instructions.
Harness Schematic for Sandia STX-165R and Navworx ADS600-EXP ADS-B
Attached is the schematic for the available combined H-Navworx/STX165R harness for connecting both the Navworx ADS600-EXP ADS-B (Experimental) and the Sandia STX-165R Remote Mode C Transponder. The RS-232 wires from the STX-165R can be connected to ...
Setup of the uAvionix EchoUAT ADS-B with the iEFIS and iEFIS Lite
First, wire the EchoUAT to the iEFIS according to this article. The article shows using the EchoUAT with the Sandia transponder, but other transponders can be used. Then, follow the instructions below: Note: With the EchoUAT, the EFIS does NOT ...
Sandia STX 165R Remote Mode-C Transponder Connection Manual
Attached is the manual for connecting the Sandia STX 165R Remote Mode-C Transponder to the MGL Avionics Odyssey/Voyager, XTreme and iEFIS systems. Also attached is the harness schematic for the unit. Note: Only the remote-mount STX 165R (and not the ...
SP-12 TABS GPS Manual and Harness Schematic and ADS-B setup manual
Below is the manual and wiring schematic (for the available harness) for the MGL Avionics SP-12 GPS (for 2020-compliant position sourcing for ADS-B Out devices for Experimentals and LSAs). Also, the iEFIS Mode-S and ADS-B Setup Instructions are ...
Navworx ADS600-B ADS-B Integration Guide
Attached is the Integration Document for Navworx ADS600-B ADS-B (certified unit) and MGL Avionics Odyssey or Voyager Gen 2 EFIS, and iEFIS. Draft document by Cecil Jones. Also attached is a connection schematic for the iEFIS and the Navworx ADS600-B ...