iEFIS LCD Display Dimensions

iEFIS LCD Display Dimensions

Below are the LCD screen dimensions for the iEFIS Challenger, Explorer and Discovery displays:


Challenger (and Lite):

GENERAL SPECIFICATIONS
Ratio                                        4:3
Active Area                               210.4 (H) x 157.8 (V)mm -- (8 9/32" x 6 7/32") (10.4” diagonal)
Bezel Opening Area                   215.4 (H) x 161.8 (V)mm -- (8 31/64" x 6 3/8")
Pixel Number                            1024 x 768 pixel (RGB)


Explorer (and Lite):

GENERAL SPECIFICATIONS 
Ratio                                        5:3
Active Area                               184.8 (H) x 111.3 (V)mm -- (7 9/32" x 4 3/8") (8.5” diagonal)
Bezel Opening Area                   187.2 (H) x 113.5 (V)mm -- (7 3/8" x 4 15/32")
Pixel Number                            800 x 480 pixel (RGB)


Discovery (and Lite):

GENERAL SPECIFICATIONS 

Ratio                                        5:3
Active Area                               152.4 (H) x 91.44 (V)mm -- (6" x 3 19/32") (7.0” diagonal)
Bezel Opening Area                   153.6 (H) x 92.7 (V)mm -- (6 3/64" x 3 21/32")
Pixel Number                            800 x 480 pixel (RGB)

    • Related Articles

    • iEFIS Panel Dimensions

      Attached are the cutout panel dimensions and sizes of the iEFIS Challenger, Explorer and Discovery (Lite versions are the same size as regular units).

    • iEFIS Standard System Selections

      To setup your iEFIS and iEFIS Lite display (when using standard screen layouts - not custom) for the engine you have (example Lycoming 4/6-cyl, or Rotax or Jabiru/other 4/6 cylinder) and to setup the number of fuel tanks you have and whether you have ...

    • XTreme EFIS/EMS Dimensions Dimensions

      Attached are the dimensions and size of the XTreme EFIS and EMS

    • iEFIS WiFi Gateway Installation and Setup

      MGL iEFIS WiFi Gateway from MicroKit Installation and Setup Pre-Installation Tasks: If your unit is an iEFIS or iEFIS Lite Verify Software Revision is at least G3 1.1.2.0 If your unit is an iEFIS MX1 Verify Software Revision is at least V13 Verify ...

    • Setup of the Navworx ADS600-EXP ADS-B with the iEFIS and iEFIS Lite

      First, wire the Navworx to the iEFIS according to this article. The article shows using the Navworx with the Sandia transponder, but other transponders can be used. Then, follow the instructions below: Note: With the Navworx ADS600-EXP (Experimental ...