Infinity and Velocity Singles Calibration Mode

Several Infinity and Velocity Singles have a 'Calibrate' mode that allows you to re-calibrate sensors such as airspeed/altitude and battery current zero.

To enter calibration mode:

1. Press the knob repeatedly DURING startup of the instrument:

2. During startup you will notice the word CALIBRATE appears on the screen, but then the instrument boots as normal:

3. AFTER boot up, enter the regular menu as normal by clicking the Knob:

4. Roll the Knob until you get to the Calibrate menu (not visible in normal mode):

5. Adjust the desired calibrations:

After adjusting calibrations you may exit the menu and operate instrument as usual.

• Related Articles

• Infinity and Velocity Singles Reference Ground to Engine Block

  The Infinity and Velocity Singles Reference Ground wire is always labelled as such in the manual, and there might be one on each connector. They can be tied together and run to the Engine Block. Important: Read this article on why an Engine Block ...

• What are the dimensions of the Velocity Singles?

  Attached are the dimensions / size of the 3 1/8" Velocity Singles Applies to: ALT-3 ALT-4 ASI-3 ASX-2 AV-2 E1 EMS FF-3 Flight-2 GF-2 MAP-2 ROTOR-1 RTC-1 RV-3 TC-2 TC-3 TP-2

• What are the dimensions of the Infinity Singles?

  Attached are the dimensions / size of the 2 1/4" Infinity Singles Applies to: ALT-1 ALT-2 ASI-1 ASX-1 AV-1 BAT-1 E3 EMS FF-1 GF-1 MAP-1 RTC-2 RV-1 RV-2 TC-1 TP-1

• iEFIS Altimeter Calibration Manual

  Attached is the iEFIS Altimeter Calibration Manual

• MGL Compass Operation and Calibration Manual

  Attached is the MGL Compass Operation and Calibration Manual