Navworx ADS600-B ADS-B Integration Guide

• Related Articles

• Setup of the Navworx ADS600-EXP ADS-B with the iEFIS and iEFIS Lite

  First, wire the Navworx to the iEFIS according to this article. The article shows using the Navworx with the Sandia transponder, but other transponders can be used. Then, follow the instructions below: Note: With the Navworx ADS600-EXP (Experimental ...

• Harness Schematic for Sandia STX-165R and Navworx ADS600-EXP ADS-B

  Attached is the schematic for the available combined H-Navworx/STX165R harness for connecting both the Navworx ADS600-EXP ADS-B (Experimental) and the Sandia STX-165R Remote Mode C Transponder. The RS-232 wires from the STX-165R can be connected to ...

• Setup of the uAvionix EchoUAT ADS-B with the iEFIS and iEFIS Lite

  First, wire the EchoUAT to the iEFIS according to this article. The article shows using the EchoUAT with the Sandia transponder, but other transponders can be used. Then, follow the instructions below: Note: With the EchoUAT, the EFIS does NOT ...

• SP-12 TABS GPS Manual and Harness Schematic and ADS-B setup manual

  Below is the manual and wiring schematic (for the available harness) for the MGL Avionics SP-12 GPS (for 2020-compliant position sourcing for ADS-B Out devices for Experimentals and LSAs). Also, the iEFIS Mode-S and ADS-B Setup Instructions are ...

• Harness Schematic for Sandia STX-165R and uAvionix EchoUAT ADS-B

  Attached is the schematic for connecting both the uAvionix EchoUAT ADS-B and the Sandia STX-165R Remote Mode C Transponder. The RS-232 wires from the STX-165R can be connected to any channel on the iBox or any channel on the iEFIS Lite or iEFIS ...