XTreme EFIS / EMS Wiring Schematic (engine only) - CAN bus
Simple XTreme EFIS/EMS to RDAC XF harness schematic. Click here for full XTreme EFIS harness schematic.
Related Articles
XTreme EFIS Harness Wiring Schematics - CAN bus
Attached below are the harness schematics and pin-outs to connect the XTreme EFIS. Same harness can be used for XTreme EMS (but no AHRS sensors or servos connected). Simple XTreme EFIS/EMS and RDAC harness schematic here. XTreme 2 EFIS and EMS with RDAC VD
The new XTreme 2 EFIS and EMS (XTremes shipped from approx October 2014) no longer have the 'RDAC' optical signal wire, as they are designed for use with the RDACXF via CAN bus. However, those wanting to connect the RDAC VD to the newer XTremes can ...XTreme EFIS/EMS Dimensions Dimensions
Attached are the dimensions and size of the XTreme EFIS and EMSAeroVee Engine Sensor Setup
AeroVee (Sonex) Sensor Settings AeroVee uses the following sensors: CHT: Type-K or Type-J Thermocouple (Specified at ordering) EGT: Type-K Thermocouple Oil Pressure: VDO 5-bar sensor 360-001 Oil Temperature: VDO 150-degree Celsius sensor 323-055 ...XTreme General Connection Diagrams
General Connection Diagrams for the XTreme EFIS showing the CAN bus wiring option for connection and the legacy Airtalk / RDAC connection options.