XTreme General Connection Diagrams

• Related Articles

• XTreme and RDAC XF via Optical Connection

  Using the CAN bus where available is always recommended, such as when connecting the XTreme and RDAC XF together. However, if connecting the XTreme to the RDACXF via the legacy Optical connection, connect as follows: Opt + from RDAC XF (Pin 4) ...

• XTreme Generation 2 Updates

  Here you will find updates for your XTreme EFIS and EMS Generation 2 units.  If you have a Generation 1 unit please check the Gen 1 XTreme Update page here You can tell the difference by looking at the version number at startup. If you have a ...

• XTreme Generation 1 Updates

  Here you will find updates for your XTreme EFIS and EMS Generation 1 units.  If you have a Generation 2 unit please check the Gen 2 XTreme Update page here You can tell the difference by looking at the version number at startup. If you have a ...

• RDAC XF Connection Harness Schematics

  Legacy Optical Connection:  The RDAC XF connects to the following devices via Optical Connection: Enigma Odyssey/Voyager Gen 1 Odyssey/Voyager Gen 2 (can use Optical or CAN bus) Older XTremes (can use Optical or CAN bus - see this article) New CAN ...

• XTreme EFIS Harness Wiring Schematics - CAN bus

  Attached below are the harness schematics and pin-outs to connect the XTreme EFIS. Same harness can be used for XTreme EMS (but no AHRS sensors or servos connected). Simple XTreme EFIS/EMS and RDAC harness schematic here. ​