Westach Oil Temperature Sender

Attached are settings and wiring connections for the Westach Oil Temperature Sender. This can be used to help if you are experiencing problems or if you suspect your oil temp sender is reading incorrectly.  This is the oil temperature sender typically used on the Lycoming engine.

Remember to follow these 3 Steps first when troubleshooting senders.

• Screw in 5/8-18 UNF Threaded Westach Oil Temp sender as shown, with crush washer
• Use adapter fitting if required
• Sender has 2 black wires (interchangeable) – connect one wire to Oil Temp input and the other to RDAC Ground
• Note that EFIS will read 32 deg F (0 deg C) until you reach operating temp of 70 deg F

Wiring:

Connect 2 black wires (any way) as follows:

Black Wire	Oil Temperature Input
Black Wire	Engine Block or RDAC Ground

Setups:

Select the Westach Sender Option.

Enigma/Voyager/Odyssey and iEFIS:

XTreme:

Infinity or Velocity Single:

Note: If you have an older Single Instrument that does not have a Westach option, then follow these instructions.

• Related Articles

• Setting up the Westach Oil Temp sender as a User Sender

  To setup the Westach oil temp sender as a user sender on Infinity and Velocity Singles that do not have the Westach option, you can use the following settings: You enter these points in the User|Calibrate sender menu: For Deg Fehrenheit:  Points: 10 ...

• VDO Oil Pressure Sender Settings and Wiring

  Attached are settings and wiring connections for the commonly-used VDO Oil Pressure Sender. This can be used to help if you are experiencing problems or if you suspect your oil pressure sender is reading incorrectly. Remember to follow tthese 3 Steps ...

• Connecting the New-Style Rotax 912 Oil Pressure Sensor to the EFIS

  Attached is the manual for connecting the New-Style Rotax 912 Oil Pressure Sensor to the XTreme, Enigma, Voyager or Odyssey EFIS. This sensor is made by Honeywell. Note: when using the RDAC XF, you do not need to install the 100 ohm resistor - you ...

• UMA Tach Sender Manual

  Attached is the manual for the UMA Tach Sender for Bendix or Slick Magnetos / Mags. This is the recommended method for pickup up an RPM signal from a Lycoming or Continental engine. ​

• MGL Fuel Level Sender Calibration

  MGL Avionics Capacitance Fuel Level Sender Calibration  Senders are produced by Centroid Products MGL Avionics sell several standard lengths of capacitance probe (12" and 24" long). The senders can be bent above the black mark on the probe (first ...