iEFIS Discovery-Lite Weights and Current Draws

Below are the system weights and Current loads of the iEFIS Discovery-Lite. We recommend putting all EFIS-Lite system components on a 3 or 5 Amp Circuit Breaker. If radio and transponder are used, these can be placed on another 5 Amp Circuit breaker. If autopilot is used, both servos can share another 5 Amp Circuit Breaker.

​

• Related Articles

• iEFIS Challenger and Explorer Weights and Current Draws

  Below are the system weights and Current loads of the iEFIS Explorer and Challenger. We recommend putting all EFIS system components on a 5 Amp Circuit Breaker. If radio and transponder are used, these can be placed on another 5 Amp Circuit breaker. ...

• XTreme EFIS Weights and Current Draws

  Below are the system weights and Current loads of the XTreme mini EFIS/EMS. We recommend putting the EFIS system components on a 5 Amp Circuit Breaker. If radio and transponder are used, these can be placed on another 5 Amp Circuit breaker. If ...

• iEFIS Lite Harness Wiring Schematics

  Attached is the schematic for the available iEFIS Lite wiring harness. This harness can be used for the Discovery-Lite, Explorer-Lite and Challenger-Lite. It contains the Power/Ground connections, CAN bus connections and RS-232 connections. ​

• iEFIS-Lite to V10 RS-232 Connection Diagram

  Below is the connection diagram diagram for the iEFIS-Lite to V10 Com Radio. You can use either RS-232 Port 1 OR RS-232 Port 2 on the iEFIS-Lite (Discovery-Lite, Explorer-Lite, Challenger-Lite) Connect either RS-232 on the iEFIS-Lite to RS-232 Port 1 ...

• iEFIS-Lite to V6 RS-232 Connection Diagram

  Below is the connection diagram diagram for the iEFIS-Lite to V6 Com Radio. You can use either RS-232 Port 1 OR RS-232 Port 2 on the iEFIS-Lite (Discovery-Lite, Explorer-Lite, Challenger-Lite). You can also use any of the RS-232 Ports on the iEFIS ...