RDAC XF Connection Harness Schematics

RDAC XF Connection Harness Schematics

Legacy Optical Connection: 

The RDAC XF connects to the following devices via Optical Connection:

  • Enigma
  • Odyssey/Voyager Gen 1
  • Odyssey/Voyager Gen 2 (can use Optical or CAN bus)
  • Older XTremes (can use Optical or CAN bus - see this article)

New CAN Bus Connection: 


The RDAC XF connects to the following devices via CAN Bus Connection:

  • All iEFIS models
  • XTreme EFIS and EMS
  • Odyssey/Voyager Gen 2 (can use Optical or CAN bus)


Schematics attached.

    • Related Articles

    • iEFIS Harness Wiring Schematics

      Attached are iEFIS / iBox CAN bus harness schematics that detail connecting up the system. The iBox is connected to all devices, such as the AHRS SP-7 and SP-6, the autopilot servos, the RDAC XF, etc., via the CAN bus. There are 2 CAN buses per iBox ...

    • XTreme and RDAC XF via Optical Connection

      Using the CAN bus where available is always recommended, such as when connecting the XTreme and RDAC XF together. However, if connecting the XTreme to the RDACXF via the legacy Optical connection, connect as follows: Opt + from RDAC XF (Pin 4) ...

    • XTreme EFIS Harness Wiring Schematics - CAN bus

      Attached below are the harness schematics and pin-outs to connect the XTreme EFIS. Same harness can be used for XTreme EMS (but no AHRS sensors or servos connected). Simple XTreme EFIS/EMS and RDAC harness schematic here. ​

    • RDAC XF and RDAC XF MAP Manual

      Attached is the RDAC XF and RDAC XF MAP Manual ​

    • V10 Radio Harness Schematics

      Attached are harness schematics for connecting up Single Place, 2-place and 4-place harnesses for wiring the V10 Radio (and a dual radio harness schematic) ​