iEFIS Harness Wiring Schematics

Attached are iEFIS / iBox CAN bus harness schematics that detail connecting up the system. The iBox is connected to all devices, such as the AHRS SP-7 and SP-6, the autopilot servos, the RDAC XF, etc., via the CAN bus. There are 2 CAN buses per iBox and each CAN bus extends to devices in a daisy chain as in the diagram below. The daisy chain is terminated on each end with terminating resistors. The harnesses sold by MGL Avionics include these resistors.

​

• Related Articles

• iEFIS Lite Harness Wiring Schematics

  Attached is the schematic for the available iEFIS Lite wiring harness. This harness can be used for the Discovery-Lite, Explorer-Lite and Challenger-Lite. It contains the Power/Ground connections, CAN bus connections and RS-232 connections. ​

• V6 Radio Harness Schematics

  Attached are harness schematics for connecting up Single Place, 2-place and 4-place harnesses for wiring the V6 Radio ​

• V10 Radio Harness Schematics

  Attached are harness schematics for connecting up Single Place, 2-place and 4-place harnesses for wiring the V10 Radio (and a dual radio harness schematic) ​

• Transponder Encoder Harness Schematics

  Attached are Schematics for wiring connections for connecting the MGL Avionics iEFIS, Odyssey, Voyager, Enigma EFIS to the following transponders: Garmin GTX320A Garmin GTX327 Garmin GTX330 Bendix/King KT-76A Microair T2000

• XTreme EFIS Harness Wiring Schematics - CAN bus

  Attached below are the harness schematics and pin-outs to connect the XTreme EFIS. Same harness can be used for XTreme EMS (but no AHRS sensors or servos connected). Simple XTreme EFIS/EMS and RDAC harness schematic here. ​