RDAC
Lycoming Installation Guide
Manual for installing engine senders for Lycoming engine when using the RDAC and an MGL Avionics EFIS
RDAC XG Manual
Attached is the manual for the RDAC XG. The RDAC XG is a compact version of the RDAC XF Engine monitor module and can be used used with XTreme, Odyssey G2, Voyager G2 and all iEFIS systems. The RDAC XG provides a CAN bus interface. Further to this an ...
RDAC CAN ULP Manual
The RDAC CAN module for UL Power Engines The RDAC CAN module can be used with Odyssey/Voyager G2 EFIS systems, the XTreme EFIS and EMS as well as all iEFIS systems. The RDAC CAN module connects to the EFIS CAN bus and the CAN bus of an engine ECU ...
RDAC CAN 912iS
Attached is the manual for the RDAC CAN 912is, a special RDAC module for use with the Rotax 912iS engine. The settings to be used with this RDAC and the iEFIS and Odyssey/Voyager are included in this manual. An additional manual is attached for the ...
RDAC XF Connection Harness Schematics
Legacy Optical Connection: The RDAC XF connects to the following devices via Optical Connection: Enigma Odyssey/Voyager Gen 1 Odyssey/Voyager Gen 2 (can use Optical or CAN bus) Older XTremes (can use Optical or CAN bus - see this article) New CAN ...
XTreme and RDAC XF via Optical Connection
Using the CAN bus where available is always recommended, such as when connecting the XTreme and RDAC XF together. However, if connecting the XTreme to the RDACXF via the legacy Optical connection, connect as follows: Opt + from RDAC XF (Pin 4) ...
RDAC XF and RDAC XF MAP Manual
Attached is the RDAC XF and RDAC XF MAP Manual
RDAC XB and XD Manual
Attached is the RDAC XB and RDAC XD Manual. This RDAC is discontinued and has been replaced by the RDAC XF and RDAC XF MAP
RDAC VD Manual
Attached is the RDAC VD Manual
RDAC XF and XF MAP Reference Ground to Engine Block
The RDAC XF and XF MAP Pins 5 and 9 on the DB9 connector are connected Directly to Engine Block Ground Note: It is acceptable to Setup a Ground Bus on the Firewall where all of your senders that require an Engine Block Ground are Grounded. This Bus ...
RDAC XB and XD Reference Ground to Engine Block
With the RDAC XB or XD, the Reference Ground wire is the Black Ground wire that comes out the top of the RDAC, together with the Red Power Supply Wire. This wire should go straight to the Engine Block. Note: It is acceptable to Setup a Ground Bus on ...
RDAC VD Reference Ground to Engine Block
On the RDAC VD, the Reference Ground wire is the bottom terminal on the RDAC, labelled REF GND. This terminal should go straight to Engine Block. Important: Read this article on why an Engine Block Reference Ground is critical for accurate engine ...
Thermocouple Order - which goes first EGT or CHT?
In all MGL Avionics instruments (except iEFIS), including Velocity Singles and Infinity Singles and all RDAC connections for MGL Avionics Enigma, Odyssey and Voyager EFISs, the following rules apply regarding the order in which EGT and CHT probes are ...